2021 Ram 1500

Removal and Installation

Air Suspension Reservoir

▸Contents: 02 - Front Suspension

REMOVAL

WARNING:

All pressurized air suspension components contain high pressure air (up to 220 psig). Use extreme caution when inspecting for leaks. Wear safety goggles and adequate protective clothing when inspecting or servicing the air suspension system. A sudden release of air under this amount of pressure can cause possible serious or fatal injury.

WARNING:

Before performing any service on the air suspension system, the system must be disabled to prevent the system from changing ride height. Before any given component is to be serviced it must be deflated. Servicing the air suspension system without the system disabled, or with pressure in any specific component, can cause possible serious or fatal injury.

  1. Perform the manual reservoir deflate standard procedure (Refer to 02 - Front Suspension/Air Suspension - Standard Procedure) .
  2. Raise and support the vehicle (Refer to 04 - Vehicle Quick Reference/Hoisting - Standard Procedure) .
  3. Remove the rear wheels.
  4. Remove the spare tire.
  5. Remove the spare tire right and left heatshield (Refer to 11 - Exhaust System/SHIELD, Heat/Removal and Installation) .
  6. Remove the left and right rear wheelhouse splash shield (Refer to 23 - Body/Exterior/SHIELD, Splash/Removal and Installation) .
  7. Remove the left side exhaust isolator fasteners.

    1 - Exhaust Isolator
  8. Lower the exhaust pipeline for clearance.
  9. Disconnect the reservoir air line fitting from the air reservoir.

    1 - Air Line Nut
    2 - Fill Port Bracket Bolt
    3 - Reservoir Air Line
    4 - Reservoir Fill Connection Cap

  10. Remove the four air reservoir bracket fasteners.

    1 - Air Reservoir Bolts
    2 - Air Reservoir Bolts
  11. Remove the left side reservoir fasteners.
  12. Raise/lower the vehicle.
  13. Remove the reservoir from the vehicle.
 

INSTALLATION

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

WARNING:

All pressurized air suspension components contain high pressure air (up to 220 psig). Use extreme caution when inspecting for leaks. Wear safety goggles and adequate protective clothing when inspecting or servicing the air suspension system. A sudden release of air under this amount of pressure can cause possible serious or fatal injury.

WARNING:

Before performing any service on the air suspension system, the system must be disabled to prevent the system from changing ride height. Before any given component is to be serviced it must be deflated. Servicing the air suspension system without the system disabled, or with pressure in any specific component, can cause possible serious or fatal injury.