2021 Ram 1500

Diagnosis And Testing

Air Suspension

▸Contents: 02 - Front Suspension

WARNING:

All pressurized air suspension components contain high pressure air (up to 220 psig). Use extreme caution when inspecting for leaks. Wear safety goggles and adequate protective clothing when inspecting or servicing the air suspension system. A sudden release of air under this amount of pressure can cause possible serious or fatal injury.

WARNING:

Before performing any service on the air suspension system, the system must be disabled to prevent the system from changing ride height. Before any given component is to be serviced it must be deflated. Servicing the air suspension system without the system disabled, or with pressure in any specific component, can cause possible serious or fatal injury.

CAUTION:

Never introduce any foreign material into the air suspension system. Only use nitrogen with a Purity Class 5 (99.999% pure). The use of any other material may result in component damage.

Always check for Diagnostic Trouble Codes (DTCs) as the first step of an air leak check. Some DTCs can point to a specific area of the vehicle as a starting point. Use a watered down liquid soap and a spray bottle to perform air leak diagnosis. Apply a liberal spray and inspect for air bubbles in the area of concern.

  1. Perform the Component Air Mass/Pressure/Ride Height Readings routine to check the system air mass. If the air mass is low, fill the system (Refer to 02 - Front Suspension/Air Suspension/Standard Procedure) .
  2. With a scan tool, set the ride height level to Off Road 2.
  3. Once the ride height level has been successfully set, select “close” on the scan tool. This will leave the vehicle in the In-Plant Mode.
  4. With the scan tool, perform the Component Air Mass/Pressure/Ride Height Readings routine. Record all five pressure readings.
  5. Read and record all four ride height sensor readings from the “data” tab on the scan tool.

    NOTE:

    Try to avoid large temperature changes between any points in this procedure. Air pressure is sensitive to temperature and any change in temperature will result in a change in pressure which will make an accurate assessment difficult to complete.

  6. Disconnect the scan tool and turn the ignition OFF, then let the vehicle sit for at least four hours.
  7. Disable the air suspension system by putting it in Jack Mode.

    NOTE:

    The air suspension system can be disabled and enabled by using the Display Screen Module (DSM) in the vehicle under tire jack mode.


    NOTE:

    Verify the top and bottom LEDs on the leveling switch are ON before allowing the vehicle to sit for the specified time. This indicates that vehicle leveling has been disabled. It is required that the leveling feature remain disabled for the entire wait time.

  8. After the vehicle has been sitting for at least 4 hours, turn the ignition on. With the scan tool, read the ride height sensor values. Compare these readings to the original. A sensor reading decrease of more than 10 mm (0.39 in.) relative to the others will indicate that the corresponding air-spring circuit has a leak in it. Repeat the procedures for checking ride height and pressure values. Compare the original values to the new readings of both ride height and pressures to determine which suspension corner varies relative to the others.
  9. Compare the reservoir before and after pressure readings. A decrease in pressure will indicate that there is an air leak in the reservoir circuit.
  10. Once it has been determined that a leak is present, use a watered down liquid soap in a spray bottle to perform air leak diagnosis. Apply a liberal spray and inspect for air bubbles in the area of concern. Repair as necessary according to the relevant repair procedures.
  11. Once the air suspension system is repaired and filled, run the sensor ride height routine as a final check. Passing this test verifies compressor functionality, proper air mass, proper sensor orientation, and linkage orientation. Clear any Diagnostic Trouble Codes (DTCs) in the Air Suspension Control Module (ASCM) to complete the repair.