Standard Procedure
Recalibration Of Sensors And Modules
▸Contents: 31 - Collision Information
Position Statements
- Authentic Mopar® Glass Replacement
- Reconditioned Wheel Usage
- Replacement Seat Covers And Seat Cover Repairs
- Salvaged Air Bags Or Other Salvaged Restraint System Component Usage
- SCAN TOOL SUPPORT BEFORE and AFTER COLLISION REPAIR
- Steering System
- Repair Parts Used For Structural Repairs
- Use Of Aftermarket Parts
- Use Of Heat While Repairing Damaged Structural And Non-Structural Components
- Use Of Optional Oe Parts
- Bumper/Fascia Repair With Adas
- One-Time-Use Parts & Fasteners
Standard Procedure
- Service After A Supplemental Restraint System Deployment
- Handling Non-Deployed Supplemental Restraints
- Post Collision Seat Belt Inspection
- Post Collision Scan Tool Inspection
- Recalibration Of Sensors And Modules
- Basecoat/Clearcoat Finish
- Finesse Sanding, Buffing, And Polishing
- Paint Touch-Up
- Rivet Nut Procedure
- Roof Panel Weld Stud
- Non-Structural Sheet Metal Repair
- Welding And Weld Bonding
- Sectioning Locations And Procedures
- Hoisting And Jacking
- Stationary Glass
- Corrosion Protection
Approved Materials
During the collision repair process, depending on the type and location of the damage, sensors and modules of electronic systems that are removed and/or replaced. These system sensors, modules and motors may require recalibration, relearning, initialization or verification testing.
These systems and components may include but are not limited to-
- Occupant restraint systems such as- air bags, seat belt tensioners. impact sensors and Occupant Restraint Controller (ORC)
- Vehicle safety systems such as- Lane Departure Warning (LDW), Adaptive Cruise Control (ACC), Anti-lock Brake System (ABS) and park assist
- Vehicle options such as- power liftgate, power roof systems, power windows and power seat systems.
- Vehicle standard functions such as- Body Control Module (BCM), Powertrain Control Module (PCM) and door module
Access to the service information will be necessary to perform the procedures. The service information can be found on techCONNECT™ and techAUTHORITY™.
The procedures may require one or a combination of- The procedures may require one or a combination of-
- wiTECH™ scan tool
- Specialty tools or equipment (for example; Forward Facing Camera (FFC)
- Established driving parameters
- Operation of the component’s switches
If the wiTECH™ scan tool is not available it can be obtained through an FCA US dealership service center.