Position Statements
Steering System
▸Contents: 31 - Collision Information
Position Statements
- Authentic Mopar® Glass Replacement
- Reconditioned Wheel Usage
- Replacement Seat Covers And Seat Cover Repairs
- Salvaged Air Bags Or Other Salvaged Restraint System Component Usage
- SCAN TOOL SUPPORT BEFORE and AFTER COLLISION REPAIR
- Steering System
- Repair Parts Used For Structural Repairs
- Use Of Aftermarket Parts
- Use Of Heat While Repairing Damaged Structural And Non-Structural Components
- Use Of Optional Oe Parts
- Bumper/Fascia Repair With Adas
- One-Time-Use Parts & Fasteners
Standard Procedure
- Service After A Supplemental Restraint System Deployment
- Handling Non-Deployed Supplemental Restraints
- Post Collision Seat Belt Inspection
- Post Collision Scan Tool Inspection
- Recalibration Of Sensors And Modules
- Basecoat/Clearcoat Finish
- Finesse Sanding, Buffing, And Polishing
- Paint Touch-Up
- Rivet Nut Procedure
- Roof Panel Weld Stud
- Non-Structural Sheet Metal Repair
- Welding And Weld Bonding
- Sectioning Locations And Procedures
- Hoisting And Jacking
- Stationary Glass
- Corrosion Protection
Approved Materials
SUBJECT: Steering System Inspection After a Collision
OVERVIEW: This information documents the FCA US LLC position regarding conditions under which replacement or repair of steering system components are required.
MODELS: All (All) FCA Group vehicles
| NOTE: |
This information applies to vehicles within the following markets/countries: NAFTA, APAC, EMEA and LATAM. |
DISCUSSION: Steering Column - If the vehicle is involved in a collision where the airbag has been deployed or the steering wheel is visually deformed, then steering column replacement is required. Internal component damage from such an event may not be visible; however, steering column replacement is required.
Steering Rack/Gear - If the vehicle is involved in a collision and visual damage or deformation is identified on the steering rack/gear, the repair facility must check for the conditions listed below before returning the vehicle to the customer. If one or more conditions from the list below are confirmed to be present, follow the Steering System Diagnosis & Testing instructions in FCA’s published Service Information to correct the condition.
| NOTE: |
Correction of the conditions below may not require rack/gear replacement. |
- Steering wheel is off center
- Vehicle pulls left or right
- Perceived column/steering wheel free play
- Steering wheel has fore and aft looseness
- Perceived dash, vehicle, steering wheel vibration by driver
- Difficult steering in either or both directions
- Steering catches/sticks
- Steering wheel does not return to center position
- Excessive road feedback
- Noise or vibration such as rattle, excessive clunk, popping, squeaking/rubbing, scrubbing/knocking
Genuine Mopar Parts
FCA US LLC vehicles and authentic Mopar Parts are designed and manufactured to meet production engineered specifications, while maximizing the safety of all occupants in a collision. If a collision repair is necessary, all repairs should be performed by a certified trained technician and follow vehicle-specific repair procedures available at TechAuthority.com using only genuine Mopar parts. Failure to follow proper procedures or deviation from Original Equipment parts could result in compromising performance of impact safety systems. Only authentic Mopar Parts are designed and built to provide optimum fit, function, safety and structural integrity as well as being engineered, manufactured and tested to the FCA US LLC internal and government-mandated standards and are the only parts equivalent to the originally installed parts. These parts are carefully designed to act as a safety system and are rigorously impact tested to ensure optimal performance.
Use of Aftermarket Parts
FCA US LLC does not approve of the use of aftermarket, third-party replacement parts, recycled, salvaged, aftermarket or reconditioned parts. Aftermarket parts are not subject to the same requirements of entire vehicle operation or function and may not be manufactured to the same standards or design. This could compromise the overall safety of the vehicle should a future collision occur. Aftermarket parts may not be built to FCA US LLC’s exact design and can therefore affect the performance of important structural and safety features of the vehicle.
This bulletin is supplied as technical information only and is not an authorization for repair. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying or otherwise, without written permission of FCA US LLC.
For more information, log on to: www.MoparRepairConnect.com.
Release Date: December 01, 2025
FCA US LLC vehicle lease agreements specify that ONLY genuine Mopar replacement parts be utilized for collision repairs to the vehicle.
POLICY: Information Only
©2026 FCA US LLC. All Rights Reserved. Chrysler, Dodge, Jeep, Ram, Mopar and SRT are registered trademarks of FCA US LLC. FIAT is a registered trademark of FCA Group Marketing S.p.A., used under license by FCA US LLC.