Standard Procedure
Post Collision Seat Belt Inspection
▸Contents: 31 - Collision Information
Position Statements
- Authentic Mopar® Glass Replacement
- Reconditioned Wheel Usage
- Replacement Seat Covers And Seat Cover Repairs
- Salvaged Air Bags Or Other Salvaged Restraint System Component Usage
- SCAN TOOL SUPPORT BEFORE and AFTER COLLISION REPAIR
- Steering System
- Repair Parts Used For Structural Repairs
- Use Of Aftermarket Parts
- Use Of Heat While Repairing Damaged Structural And Non-Structural Components
- Use Of Optional Oe Parts
- Bumper/Fascia Repair With Adas
- One-Time-Use Parts & Fasteners
Standard Procedure
- Service After A Supplemental Restraint System Deployment
- Handling Non-Deployed Supplemental Restraints
- Post Collision Seat Belt Inspection
- Post Collision Scan Tool Inspection
- Recalibration Of Sensors And Modules
- Basecoat/Clearcoat Finish
- Finesse Sanding, Buffing, And Polishing
- Paint Touch-Up
- Rivet Nut Procedure
- Roof Panel Weld Stud
- Non-Structural Sheet Metal Repair
- Welding And Weld Bonding
- Sectioning Locations And Procedures
- Hoisting And Jacking
- Stationary Glass
- Corrosion Protection
Approved Materials
Following any collision inspect the seat belts for proper function and operation prior to returning the vehicle to the customer.
If the collision event was severe enough to activate any of the Supplemental Restraint System (SRS) components (Refer to 31 - Collision Information/Standard Procedure/Service After Supplemental Restraint Deployment) to determine if there are any mandatory replacement of seat belt components.
| NOTE: | The following inspections, where applicable, are for the driver and all passenger positions, including the Lower Anchors and Tethers for Children (LATCH) restraint systems. |
- Inspect the seat belt, for fraying, cuts, fading and torn or loose stitching. If any of these condition exist replace the seat belt.
- Inspect all of the seat belt buckles for proper latching and releasing operation. If it does not function properly, replace the seat belt buckle.
- Inspect the seat belt retractor by slowly extending the seat belt fully. It should extend smoothly without binding or locking. If it does not function properly, replace the seat belt.
- Inspect the seat belt retractor by latching the seat belt and then pulling the belt quickly. The seat belt should lock. If it does not function properly, replace the seat belt.
- Inspect the seat belt shoulder turning loop to be certain it rotates freely without binding. If it does not travel freely, replace the seat belt.
- Inspect the seat belt turning loop height adjuster. It should move freely and lock firmly into the different height positions. If it does not function properly, replace the seat belt turning loop height adjuster.
| NOTE: | If any of the seat belt components have physical damage or are doubtful of proper operation, replace the component. |