Removal and Installation
Hub And Bearing
▸Contents: 02 - Front Suspension
- Special Tools
Air Suspension
- Warning
- Description and OperationAir Suspension
- Diagnosis And Testing
Standard Procedure
- Technical SpecificationsTorque Specifications
Air Line
COMPRESSOR ASSEMBLY, Air Suspension
HOSE ASSEMBLY, Air Suspension
RESERVOIR, Air Suspension
SENSOR, Height
Removal and Installation
Front, Independent Front Suspension
- Description and OperationFront Suspension
Diagnosis and Testing
- Technical SpecificationsTorque Specifications
ARM, Lower Control
Removal and Installation
ARM, Upper Control
Removal and Installation
BALL JOINT, Suspension, Lower
BALL JOINT, Suspension, Upper
KNUCKLE, Steering
LINK, Stabilizer Bar
Removal and Installation
SHOCK ABSORBER, Suspension
Removal and Installation
SPRING, Front
Removal and Installation
STABILIZER BAR, Front
Wheel Alignment
REMOVAL
- Raise and support the vehicle (Refer to 04 - Vehicle Quick Reference/Hoisting/Standard Procedure) .
- Remove the wheel and tire assembly (Refer to 22 - Tires and Wheels/Removal and Installation) .
- Have a helper apply brake pressure, then remove and DISCARD the halfshaft nut, if equipped.
1 - Bolt 2 - Halfshaft Nut - Remove the front brake caliper adapter as an assembly with the front brake caliper from the steering knuckle (Refer to 05 - Brakes/BRAKE ASSEMBLY/Disassembly and Assembly) .
- Remove the front brake rotor (Refer to 05 - Brakes/BRAKE ASSEMBLY/Disassembly and Assembly) .
- Remove the front wheel speed sensor (Refer to 05 - Brakes/SENSORS/Removal and Installation) .
- Remove the three hub and bearing bolts.
1 - Hub and Bearing Bolts 2 - Halfshaft - Slide the hub and bearing out of the steering knuckle and clear of the halfshaft.
- Remove the hub and bearing and retain the brake rotor shield.
INSTALLATION
Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.
- When installing the hub and bearing the halfshaft splines must engage the hub and bearing splines.
- Align the brake rotor shield to the steering knuckle and slide the hub and bearing over the halfshaft splines through the brake rotor shield and into the steering knuckle.
- Install a NEW halfshaft nut, if equipped.
- Have a helper apply brake pressure and tighten the halfshaft nut.
TORQUE SPECIFICATIONS - FRONT SUSPENSION