Removal and Installation
Front Coil Spring
▸Contents: 02 - Front Suspension
- Special Tools
Air Suspension
- Warning
- Description and OperationAir Suspension
- Diagnosis And Testing
Standard Procedure
- Technical SpecificationsTorque Specifications
Air Line
COMPRESSOR ASSEMBLY, Air Suspension
HOSE ASSEMBLY, Air Suspension
RESERVOIR, Air Suspension
SENSOR, Height
Removal and Installation
Front, Independent Front Suspension
- Description and OperationFront Suspension
Diagnosis and Testing
- Technical SpecificationsTorque Specifications
ARM, Lower Control
Removal and Installation
ARM, Upper Control
Removal and Installation
BALL JOINT, Suspension, Lower
BALL JOINT, Suspension, Upper
KNUCKLE, Steering
LINK, Stabilizer Bar
Removal and Installation
SHOCK ABSORBER, Suspension
Removal and Installation
SPRING, Front
Removal and Installation
STABILIZER BAR, Front
Wheel Alignment
REMOVAL
- Raise and support the vehicle (Refer to 04 - Vehicle Quick Reference/Hoisting/Standard Procedure) .
- Remove the shock absorber (Refer to 02 - Front Suspension/Front/SHOCK ABSORBER, Suspension/Removal and Installation) .
- Compress the coil spring in a suitable strut spring compressor.
1 - Strut Rod Nut 5 - Spring Isolator 2 - Upper Strut Mount 6 - Jounce Bumper 3 - Upper Spacer 7 - Coil Spring 4 - Shield 8 - Shock Absorber - Have a helper support the shock absorber from below, hold the strut rod with a suitable socket then use tool Kit, Remover - Installer Shock / Strut 2027800020 to remove the strut rod nut.
- Remove the upper strut mount, the upper spacer, the shield, the spring isolator, the jounce bumper, and the shock absorber.
- Release the spring compressor and remove the coil spring from the strut spring compressor.
INSTALLATION
Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.
- Compress the coil spring in a suitable strut spring compressor.
- Have a helper position the shock absorber to the coil spring from below and verify that the coil spring lower end is correctly aligned to the spring stop as shown.
- Have a helper support the shock absorber from below, hold the strut rod with a suitable socket then use tool Wrench, Strut Nut 9362 to install the strut rod nut and tighten to the proper (Torque Specifications) .
- Release the spring compressor and remove the strut assembly from the strut spring compressor.
TORQUE SPECIFICATIONS - FRONT SUSPENSION