Standard Procedure
Setting Ride Height Values
▸Contents: 02 - Front Suspension
- Special Tools
Air Suspension
- Warning
- Description and OperationAir Suspension
- Diagnosis And Testing
Standard Procedure
- Technical SpecificationsTorque Specifications
Air Line
COMPRESSOR ASSEMBLY, Air Suspension
HOSE ASSEMBLY, Air Suspension
RESERVOIR, Air Suspension
SENSOR, Height
Removal and Installation
Front, Independent Front Suspension
- Description and OperationFront Suspension
Diagnosis and Testing
- Technical SpecificationsTorque Specifications
ARM, Lower Control
Removal and Installation
ARM, Upper Control
Removal and Installation
BALL JOINT, Suspension, Lower
BALL JOINT, Suspension, Upper
KNUCKLE, Steering
LINK, Stabilizer Bar
Removal and Installation
SHOCK ABSORBER, Suspension
Removal and Installation
SPRING, Front
Removal and Installation
STABILIZER BAR, Front
Wheel Alignment
- Perform the curb height measurement standard procedure (Refer to 02 - Front Suspension/Wheel Alignment/Standard Procedure) .
- Using a scan tool in Air Suspension Control Module (ASCM) perform the following:
- Perform the Write Suspension Height Values routine and input measurements recorded as prompted by scan tool.
- Command the vehicle to Normal Ride Height (NRH).
- Run the Air Mass Calculation routine on the air suspension system.
- Run the Height Sensor Check routine on the air suspension system.
- Enable Level Control.