Removal and Installation
Air Suspension Reservoir
▸Contents: 02 - Front Suspension
- Special Tools
Air Suspension
- Warning
- Description and OperationAir Suspension
- Diagnosis And Testing
Standard Procedure
- Technical SpecificationsTorque Specifications
Air Line
COMPRESSOR ASSEMBLY, Air Suspension
HOSE ASSEMBLY, Air Suspension
RESERVOIR, Air Suspension
SENSOR, Height
Removal and Installation
Front, Independent Front Suspension
- Description and OperationFront Suspension
Diagnosis and Testing
- Technical SpecificationsTorque Specifications
ARM, Lower Control
Removal and Installation
ARM, Upper Control
Removal and Installation
BALL JOINT, Suspension, Lower
BALL JOINT, Suspension, Upper
KNUCKLE, Steering
LINK, Stabilizer Bar
Removal and Installation
SHOCK ABSORBER, Suspension
Removal and Installation
SPRING, Front
Removal and Installation
STABILIZER BAR, Front
Wheel Alignment
REMOVAL
| WARNING: |
All pressurized air suspension components contain high pressure air (up to 220 psig). Use extreme caution when inspecting for leaks. Wear safety goggles and adequate protective clothing when inspecting or servicing the air suspension system. A sudden release of air under this amount of pressure can cause possible serious or fatal injury. |
| WARNING: |
Before performing any service on the air suspension system, the system must be disabled to prevent the system from changing ride height. Before any given component is to be serviced it must be deflated. Servicing the air suspension system without the system disabled, or with pressure in any specific component, can cause possible serious or fatal injury. |
- Perform the manual reservoir deflate standard procedure (Refer to 02 - Front Suspension/Air Suspension - Standard Procedure) .
- Raise and support the vehicle (Refer to 04 - Vehicle Quick Reference/Hoisting - Standard Procedure) .
- Remove the rear wheels.
- Remove the spare tire.
- Remove the spare tire right and left heatshield (Refer to 11 - Exhaust System/SHIELD, Heat/Removal and Installation) .
- Remove the left and right rear wheelhouse splash shield (Refer to 23 - Body/Exterior/SHIELD, Splash/Removal and Installation) .
- Remove the left side exhaust isolator fasteners.
1 - Exhaust Isolator - Lower the exhaust pipeline for clearance.
- Disconnect the reservoir air line fitting from the air reservoir.
1 - Air Line Nut 2 - Fill Port Bracket Bolt 3 - Reservoir Air Line 4 - Reservoir Fill Connection Cap - Remove the four air reservoir bracket fasteners.
1 - Air Reservoir Bolts 2 - Air Reservoir Bolts - Remove the left side reservoir fasteners.
- Raise/lower the vehicle.
- Remove the reservoir from the vehicle.
INSTALLATION
Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.
| WARNING: |
All pressurized air suspension components contain high pressure air (up to 220 psig). Use extreme caution when inspecting for leaks. Wear safety goggles and adequate protective clothing when inspecting or servicing the air suspension system. A sudden release of air under this amount of pressure can cause possible serious or fatal injury. |
| WARNING: |
Before performing any service on the air suspension system, the system must be disabled to prevent the system from changing ride height. Before any given component is to be serviced it must be deflated. Servicing the air suspension system without the system disabled, or with pressure in any specific component, can cause possible serious or fatal injury. |
- Perform the complete system fill standard procedure (Refer to 02 - Front Suspension/Air Suspension - Standard Procedure) .
- Perform the Air Suspension Control Module (ASCM) verification test (Refer to 28 - DTC-Based Diagnostics/MODULE, Air Suspension Control (ASCM) - Standard Procedure) .
TORQUE SPECIFICATIONS - AIR SUSPENSION