Removal and Installation
Front Stabilizer Bar
▸Contents: 02 - Front Suspension
- Special Tools
Air Suspension
- Warning
- Description and OperationAir Suspension
- Diagnosis And Testing
Standard Procedure
- Technical SpecificationsTorque Specifications
Air Line
COMPRESSOR ASSEMBLY, Air Suspension
HOSE ASSEMBLY, Air Suspension
RESERVOIR, Air Suspension
SENSOR, Height
Removal and Installation
Front, Independent Front Suspension
- Description and OperationFront Suspension
Diagnosis and Testing
- Technical SpecificationsTorque Specifications
ARM, Lower Control
Removal and Installation
ARM, Upper Control
Removal and Installation
BALL JOINT, Suspension, Lower
BALL JOINT, Suspension, Upper
KNUCKLE, Steering
LINK, Stabilizer Bar
Removal and Installation
SHOCK ABSORBER, Suspension
Removal and Installation
SPRING, Front
Removal and Installation
STABILIZER BAR, Front
Wheel Alignment
REMOVAL
- Raise and support the vehicle (Refer to 04 - Vehicle Quick Reference/Hoisting/Standard Procedure) .
- Disconnect both stabilizer bar links from the stabilizer bar (Refer to 02 - Front Suspension/Front/LINK, Stabilizer Bar/Removal and Installation) .
- Remove the four stabilizer bar bolts.
1 - Stabilizer Bar Bolts - Remove the stabilizer bar, brackets, and bushings as an assembly.
- Remove the stabilizer bar brackets from the bushings.
- Remove the stabilizer bar bushings from the stabilizer bar, Do not cut the old bushings off the stabilizer bar, use a mixture of soapy water in order to aid in sliding the bushings off the stabilizer bar.
INSTALLATION
Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.
- If the bushings were removed, clean the stabilizer bar and install the bushings on the stabilizer bar using a mixture of soapy water or equivalent in order to slide the bushing over the bar with ease. Do not cut the new bushing for installation.
- Check the position of the stabilizer bar to ensure there is no interference with the either frame rail or chassis component. Spacing should be equal on both sides.
- Install the four stabilizer bar bolts and tighten to the proper torque specifications.