Removal and Installation
Power Brake Booster
▸Contents: 05 - Brakes
05 - Brakes, ABS
- Description and OperationAnti-Lock Brake System (Abs)
- Standard ProcedureStandard Procedure - Antilock Brake System Bleeding
- Technical SpecificationsTorque Specifications
Electrical
SENSOR, Wheel Speed, Front
SENSOR, Wheel Speed, Rear
SWITCH, Electronic Stability Program (ESP)
Hydraulic/Mechanical
Integrated Control Unit (Icu)
Removal and Installation
Hydraulic Control Unit (Hcu)
Removal and Installation
05 - Brakes, Base
- Warning
- Caution
- DescriptionBase Brake System
- Diagnosis And Testing
- Standard ProcedureBrake System Bleeding
- Special Tools
Technical Specifications
Electrical
SWITCH, Brake Fluid Level
Removal and Installation
SWITCH, Adjustable Pedals
PUMP, Electric Vacuum
- SENSOR, Vacuum PressureRemoval And Installation
Hydraulic/Mechanical
ADAPTER, Disc Brake Caliper
Removal and Installation
CALIPER, Disc Brake, Front
CALIPER, Disc Brake, Rear
MASTER CYLINDER, Brake
PADS, Brake, Front
PADS, Brake, Rear
PEDAL(S), Brake and/or Accelerator
ROTOR, Brake
- Diagnosis and TestingDiagnosis And Testing - Disc Brake Rotor
Removal and Installation
Parking Brake
- Description And Operation
ACTUATOR, Electric Park Brake
SWITCH, Electric Park Brake
REMOVAL
- Remove the master cylinder (Refer to 05 - Brakes, Base/Hydraulic/Mechanical/MASTER CYLINDER, Brake/Removal and Installation) .
- Disconnect the vacuum line from the brake booster.
1 - Vacuum Line 2 - Wire Harness Connector 3 - Flare Nut 4 - Master Cylinder Nut 5 - Roll-Pin - Press both of the brake booster push rod retainer tabs and forward and pull up the brake pedal to disengage the brake booster push rod from the brake pedal.
1 - Push Rod Retainer Tab 2 - Push Rod Retainer Tab - Remove the brake booster push rod retainer from the brake booster push rod then DISCARD the brake booster push rod retainer and dome.
1 - Dome 2 - Push Rod Retainer - Remove and DISCARD the brake booster nuts.
1 - Wire Harness Routing Clips 2 - Motor Wire Harness Connector 3 - Pedal Sled Fastener 4 - Brake Booster Nuts 5 - Pedal Sled Fastener - Remove the brake booster.
INSTALLATION
Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.
- Guide the brake booster pushrod and mounting studs through bulkhead.
- Install NEW brake booster nuts but do not tighten at this time .
- Tighten the brake booster nuts in sequence as shown, to the proper (Torque Specifications) .
- Lubricate with white lithium grease and assemble the NEW brake booster push rod retainer and dome.
- Press the brake booster push rod retainer into the brake pedal until it fully engages.
- Align the brake booster push rod to the brake booster push rod retainer and apply pressure to the brake pedal until the push rod locks into the brake booster push rod retainer. Gently pull up on the brake pedal to verify engagement.