Removal and Installation
Front Wheel Speed Sensor
▸Contents: 05 - Brakes
05 - Brakes, ABS
- Description and OperationAnti-Lock Brake System (Abs)
- Standard ProcedureStandard Procedure - Antilock Brake System Bleeding
- Technical SpecificationsTorque Specifications
Electrical
SENSOR, Wheel Speed, Front
SENSOR, Wheel Speed, Rear
SWITCH, Electronic Stability Program (ESP)
Hydraulic/Mechanical
Integrated Control Unit (Icu)
Removal and Installation
Hydraulic Control Unit (Hcu)
Removal and Installation
05 - Brakes, Base
- Warning
- Caution
- DescriptionBase Brake System
- Diagnosis And Testing
- Standard ProcedureBrake System Bleeding
- Special Tools
Technical Specifications
Electrical
SWITCH, Brake Fluid Level
Removal and Installation
SWITCH, Adjustable Pedals
PUMP, Electric Vacuum
- SENSOR, Vacuum PressureRemoval And Installation
Hydraulic/Mechanical
ADAPTER, Disc Brake Caliper
Removal and Installation
CALIPER, Disc Brake, Front
CALIPER, Disc Brake, Rear
MASTER CYLINDER, Brake
PADS, Brake, Front
PADS, Brake, Rear
PEDAL(S), Brake and/or Accelerator
ROTOR, Brake
- Diagnosis and TestingDiagnosis And Testing - Disc Brake Rotor
Removal and Installation
Parking Brake
- Description And Operation
ACTUATOR, Electric Park Brake
SWITCH, Electric Park Brake
REMOVAL
- Disconnect and isolate the negative battery cable(s) (Refer to 08 - Electrical/Battery System/Standard Procedure) .
- Raise and support the vehicle (Refer to 04 - Vehicle Quick Reference/Hoisting/Standard Procedure) .
- Remove the front brake rotor (Refer to 05 - Brakes/BRAKE ASSEMBLY/Disassembly and Assembly) .
- Remove the front wheel speed sensor bolt.
1 - Wheel Speed Sensor Harness 2 - Front Wheel Speed Sensor Bolt - Remove the wheel speed sensor from the hub and carefully remove the wheel speed sensor through the window of the brake rotor splash shield.
- Disengage the wheel speed sensor harness from the wheel speed sensor routing bracket.
- Disengage the wheel speed sensor harness from the upper control arm.
1 - Brake Hose Banjo Bolt 2 - Wheel Speed Sensor Wire Routing Clip 3 - Bolt 4 - Brake Line Flare Nut - Disengage wheel speed sensor harness routing clips and disconnect the wheel speed sensor wire harness connector.
1 - Wheel Speed Sensor Harness Routing Clip 2 - Wheel Speed Sensor Harness Routing Clip 3 - Wheel Speed Sensor Wire Harness Connector - Remove the wheel speed sensor.
INSTALLATION
Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.
- Grease (supplied in the sensor kit) MUST be applied to bearing-sensor interface before sensor installation to maintain a watertight seal.
- Apply grease to the wheel speed sensor at the hub surface interface.
- Carefully position the wheel speed sensor through the window of the brake rotor splash shield and insert the wheel speed sensor in the hub.
TORQUE SPECIFICATIONS - WHEEL SPEED SENSOR