2023 Ram 1500

Removal and Installation

Integrated Control Unit (Icu) With Trx

▸Contents: 05 - Brakes

REMOVAL

  1. Disconnect and isolate the negative battery cable(s) (Refer to 08 - Electrical/Battery System/Standard Procedure) .
  2. Remove the front skid plate (Refer to 13 - Frame and Bumpers/Under Body Protection/PLATE, Skid, Front/Removal and Installation) .
  3. Remove the front wheelhouse splash shield (Refer to 23 - Body/Exterior/SHIELD, Splash/Removal and Installation) .
  4. Using a brake pedal holding tool, depress the brake pedal past its first inch of travel and hold it in this position. Holding the brake pedal in this position will isolate the master cylinder from the hydraulic brake system and will not allow brake fluid to drain out of the brake fluid reservoir while brake lines are open.
  5. Remove the Hydraulic Control Unit (HCU) inlet brake line flare nuts from the Hydraulic Control Unit (HCU).

    1 - Wire Harness Connector 4 - ABS Module Fastener
    2 - Flare Nut 5 - Flare Nut
    3 - Flare Nut 6 - Bracket Bolt
  6. Remove the Hydraulic Control Unit (HCU) outlet brake line flare nuts from the HCU.

    NOTE:

    The Anti-Lock Brake System (ABS) module wire harness connector is cam-lock type and requires the red safety clip to be released for removal of the connector.

  7. Disconnect ABS module wire harness connector.
  8. Remove the Hydraulic Control Unit (HCU) bracket bolts.
  9. Disengage the wire harness retainer from the Hydraulic Control Unit (HCU) bracket.
  10. Disengage the wire harness routing clip.

    1 - Wire Harness Routing Clip
    2 - HCU Bracket Bolt
  11. Remove the Hydraulic Control Unit (HCU) bracket bolt.
  12. Remove the Integrated Control Unit (ICU) and Hydraulic Control Unit (HCU) bracket and as an assembly.

    1 - HCU Bolts
    2 - ABS Bolts
  13. Remove the two Hydraulic Control Unit (HCU) bolts and separate the ICU from the HCU bracket.
 

INSTALLATION

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.