2023 Ram 1500

Removal and Installation

Electric Parking Brake Switch

▸Contents: 05 - Brakes

REMOVAL

  1. Disconnect and isolate the negative battery cable(s) (Refer to 08 - Electrical/Battery System/Standard Procedure) .
  2. Open the screw cover.

    1 - Screw Cover

  3. Remove the screws.

    1 - Screws
  4. Remove the Electric Park Brake (EPB) switch bezel by pulling the upper retaining tabs out of the instrument panel.
  5. Disconnect the EPB switch wire harness connector, the adjustable pedal switch wire harness connector, and the power outlet switch wire harness connector, if equipped.

    1 - EPB Switch Wire Harness Connector
    2 - Power Outlet Switch Wire Harness Connector
    3 - Adjustable Pedal Switch Wire Harness Connector

  6. Remove the EPB switch screws and remove the EPB switch.

    1 - EPB Switch Screws
    2 - Adjustable Pedal Switch Screws

 

INSTALLATION

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

  • Position the Electric Park Brake (EPB) switch in the switch bezel then install and tighten the EPB switch screws.
  • Snap the upper retaining tabs into the instrument panel, then install and tighten the screws.