Removal and Installation
Electric Vacuum Pump 5.7l
▸Contents: 05 - Brakes
05 - Brakes, ABS
- Description and OperationAnti-Lock Brake System (Abs)
- Standard ProcedureStandard Procedure - Antilock Brake System Bleeding
- Technical SpecificationsTorque Specifications
Electrical
SENSOR, Wheel Speed, Front
SENSOR, Wheel Speed, Rear
SWITCH, Electronic Stability Program (ESP)
Hydraulic/Mechanical
Integrated Control Unit (Icu)
Removal and Installation
Hydraulic Control Unit (Hcu)
Removal and Installation
05 - Brakes, Base
- Warning
- Caution
- DescriptionBase Brake System
- Diagnosis And Testing
- Standard ProcedureBrake System Bleeding
- Special Tools
Technical Specifications
Electrical
SWITCH, Brake Fluid Level
Removal and Installation
SWITCH, Adjustable Pedals
PUMP, Electric Vacuum
- SENSOR, Vacuum PressureRemoval And Installation
Hydraulic/Mechanical
ADAPTER, Disc Brake Caliper
Removal and Installation
CALIPER, Disc Brake, Front
CALIPER, Disc Brake, Rear
MASTER CYLINDER, Brake
PADS, Brake, Front
PADS, Brake, Rear
PEDAL(S), Brake and/or Accelerator
ROTOR, Brake
- Diagnosis and TestingDiagnosis And Testing - Disc Brake Rotor
Removal and Installation
Parking Brake
- Description And Operation
ACTUATOR, Electric Park Brake
SWITCH, Electric Park Brake
REMOVAL
- Disconnect and isolate the negative battery cable(s) (Refer to 08 - Electrical/Battery System/Standard Procedure) .
- Disconnect the electric vacuum pump wire harness connector and remove the wire harness from the mounting bracket.
1 - Electric Vacuum Pump Wire Harness Connector 2 - Vacuum Pump Bolts 3 - Vacuum Bracket Bolts 4 - Quick Connect Vacuum Line - Release the locking tab and disconnect the quick connect vacuum line from the vacuum pump.
- Remove the vacuum pump bolts and remove the vacuum pump.
- If necessary, remove the vacuum bracket bolts and remove the vacuum pump bracket.
INSTALLATION
Follow the removal procedure in reverse for general reassembly of the components on the vehicle.
TORQUE SPECIFICATIONS - BRAKES BASE