2023 Ram 1500

Removal and Installation

Rear Brake Caliper Adapter

▸Contents: 05 - Brakes

REMOVAL

CAUTION:

Never allow the disc brake caliper to hang from the brake hose. Damage to the brake hose will result. Provide a suitable support to hang the caliper securely.

CAUTION:

If the Electric Park Brake (EPB) switch is actuated with the caliper removed from the caliper bracket and still connected electrically, the EPB motor will fully extend causing damage to the caliper piston. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.

  1. Place the Electric Park Brake (EPB) in service mode.
  2. Raise and support the vehicle (Refer to 04 - Vehicle Quick Reference/Hoisting/Standard Procedure) .
  3. Remove the tire and wheel assembly (Refer to 22 - Tires and Wheels/Removal and Installation) .
  4. Remove the brake caliper from the brake caliper adapter (Refer to 05 - Brakes, Base/Hydraulic/Mechanical/CALIPER, Disc Brake, Front/Removal and Installation) .
  5. Remove the inboard brake pad and the outboard brake pad.

    1 - Outboard Brake Pad
    2 - Brake Pad Anti-Rattle Clips
    3 - Inboard Brake Pad
    4 - Rear Caliper Adapter Bolts
  6. Remove and DISCARD the brake pad anti-rattle clips.
  7. Remove and DISCARD the rear caliper adapter bolts.
  8. Remove the caliper adapter.
 

INSTALLATION

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

  • The brake caliper adapters must be free of rust and debris before the anti-rattle clips are installed.
  • Install NEW brake pad anti-rattle clips.
  • Position the brake caliper adapter to the axle housing then install NEW rear caliper adapter bolts.
  • Apply brake pressure several times to seat the brake pads and obtain a firm brake pedal.