Removal and Installation
Axle Shaft Bearing - M250
▸Contents: 03 - Differential and Driveline
Description and Operation
Diagnosis and Testing
ASSEMBLY, Differential
Disassembly and Assembly
Actuator/Motor
GEAR, Ring and Pinion
Removal and Installation
Joints
SHAFTS, Axle/Drive/Half
Valves
Removal and Installation
REMOVAL
- Raise and support the vehicle (Refer to 04 - Vehicle Quick Reference/Hoisting/Standard Procedure) .
- Remove the rear brake rotor (Refer to 05 - Brakes, Base/Hydraulic/Mechanical/ROTOR, Brake/Removal and Installation) .
- Using a hammer and punch, remove the axle shaft dust cover and DISCARD .
1 - Dust Cover - Remove the wheel speed sensor bolt and remove the wheel speed sensor wire harness support.
1 - Wheel Speed Sensor Bolts 2 - Wheel Speed Sensor Wire Harness Support - Remove the axle bearing bolts.
1 - Axle Bearing Bolts - Remove the axle shaft with the hub and bearing from the axle tube.
1 - Hub And Bearing - Support the hub and bearing, press out the axle shaft using a properly sized socket.
1 - Socket 2 - Hub And Bearing
INSTALLATION
- Install the axle shaft assembly into the bearing.
- Install the O-ring seal onto the bearing housing, lubricate lightly with axle lubricant.
- Place the axle shaft with the hub and bearing into the axle tube, engaging the axle shaft into the differential case assembly.
1 - Hub And Bearing - Install the bearing bolts and tighten to the proper torque specification.
1 - Axle Bearing Bolts - Install the wheel speed sensor and wheel speed sensor wire harness support.
1 - Wheel Speed Sensor Bolts 2 - Wheel Speed Sensor Wire Harness Support - Install a NEW axle shaft dust cover using a properly sized socket and hammer.
1 - Dust Cover - Install the brake rotor (Refer to 05 - Brakes, Base/Hydraulic/Mechanical/ROTOR, Brake/Removal and Installation) .
- Remove the support and lower the vehicle.
TORQUE SPECIFICATIONS - M250 DIFFERENTIAL