2023 Ram 1500

Removal and Installation

Differential Assembly - C235 - Limited Slip

▸Contents: 03 - Differential and Driveline

REMOVAL

  1. Raise and support the vehicle (Refer to 04 - Vehicle Quick Reference/Hoisting/Standard Procedure) .
  2. Remove the fill and drain plugs from the differential housing.
  3. Remove the differential cover (Refer to 03 - Differential and Driveline/COVER/Removal and Installation) .
  4. Clean the housing cavity with brake cleaner and a lint free cloth.

    NOTE:

    Do not use steam, kerosene or gasoline to clean the housing.

  5. Remove the axle shafts (Refer to 03 - Differential and Driveline/SHAFTS, Axle/Drive/Half/Removal and Installation) .

    NOTE:

    Side play resulting from bearing races being loose on case hubs requires replacement of the differential case.

  6. Mark the differential housing and bearing caps for installation reference.
  7. Remove the adjuster lock bolt and remove the adjuster lock tab.

    1 – Adjuster Lock Bolt
    2 – Adjuster Lock Tab

  8. Loosen the differential bearing cap bolts.

    1 – Differential Bearing Cap Bolts
    2 – Differential Bearing Cap

  9. Loosen the differential bearing adjusters through the axle tubes using Wrench, Differential Preload C-4164 (3).

    1 – Wrench, Differential Preload C-4164
    2 – Axle Tube

  10. Hold the differential case while removing the bearing caps.

    NOTE:

    Tag the differential bearing cups and the threaded adjusters after removal to indicate their location.


    1 – Differential Case
    2 – Bearing Cups
  11. Remove the differential case and bearing cups.
 

INSTALLATION

  1. Apply a coating of hypoid gear lubricant to the differential bearings and bearing cups.
  2. Install the differential case with the bearing cups into the housing.

    1 – Differential Case
    2 – Bearing Cups

  3. Install the differential bearing caps in their original locations.

    1 – Differential Bearing Cap Bolts
    2 – Differential Bearing Cap
  4. Install bearing cap bolts and tighten the upper bolts to 14 N⋅m (10 ft. lbs.). Tighten the lower bolts finger-tight until the bolt head is seated. Perform the differential bearing preload and adjustment procedure (Refer to 03 - Differential and Driveline/Adjustments) .
  5. Install the axle shafts (Refer to 03 - Differential and Driveline/SHAFTS, Axle/Drive/Half/Removal and Installation) .
  6. Install the differential cover (Refer to 03 - Differential and Driveline/COVER/Removal and Installation) .
  7. Fill the differential with lubricant to the proper specification (Refer to 04 - Vehicle Quick Reference/Capacities and Recommended Fluids - Specifications) .
  8. Remove the support and lower the vehicle.
 

NOTE:

Limited Slip Differential (LSD) equipped vehicles should be road tested by making 10 to 12 slow figure-eight turns. This maneuver will pump the lubricant through the clutch discs to eliminate a possible chatter noise complaint.


TORQUE SPECIFICATIONS - C235 DIFFERENTIAL