2023 Ram 1500

Removal and Installation

Removal And Installation - Single Cardan With Injected Ring

▸Contents: 03 - Differential and Driveline

REMOVAL

  1. Remove the driveshaft (Refer to 03 - Differential and Driveline/SHAFTS, Axle/Drive/Half/Removal and Installation) .
  2. Place the shaft yoke in a vise.
  3. Position the U-Joint press with the receiver on the driveshaft yoke.

    1 - U-Joint Press
    2 - Receiver

  4. Press the U-Joint bearing caps out of the shaft yoke.

    1 - U-Joint Bearing Caps
    2 - Shaft Yoke
  5. Remove the lower bearing cap from the shaft yoke.
  6. Turn the shaft over and position the press with the receiver on the shaft yoke.

    1 - Press
    2 - Receiver
  7. Press the remaining U-Joint bearing cap out of the shaft yoke.
  8. Remove the flange with the U-Joint out of the shaft yoke.

    1 - Flange
    2 - Shaft Yoke

  9. Position the U-Joint press with the receiver on the flange.

    1 - Receiver
    2 - U-Joint Press

  10. Press the U-Joint bearing caps out of the flange.

    1 - U-Joint Bearing Caps
    2 - Flange
  11. Remove the bearing cap on the outside of the flange.
  12. Position U-Joint press with receiver on flange.

    1 - Receiver
    2 - U-Joint Press
  13. Press remaining U-Joint bearing cap out of flange.
  14. Remove U-Joint from flange.
  15. Clean remaining injected plastic ring material from all of the yoke and flange grooves.
 

INSTALLATION



NOTE:

The replacement U-Joint has internal snap rings.

  1. Place the U-Joint in the flange with one bearing cap.
  2. Position the press with the receiver on the flange and bearing cap.

    1 - Receiver
    2 - Bearing Cap
    3 - Press

  3. Press the bearing cap until the snap ring groove is through the flange.

    1 - Snap Ring Groove
    2 - Flange

  4. Install the snap ring on the bearing.

    1 - Bearing
    2 - Snap Ring

  5. Position the press with the receiver on the remaining bearing cap and flange.

    1 - Bearing Cap
    2 - Receiver
    3 - Press
  6. Press the bearing cap until the snap ring groove is through the flange.
  7. Install the snap ring on the bearing cap.

    1 - Snap Ring
    2 - Bearing Cap

  8. Install the flange with the U-Joint in the yoke.

    1 - Flange
    2 - Shaft Yoke

  9. Position the press with the receiver and lower the bearing cap on the yoke.

    1 - Receiver
    2 - Press
    3 - Bearing Cap
  10. Press the bearing cap until the snap ring groove is through the yoke.
  11. Install the snap ring on the bearing cap.

    1 - Bearing Cap
    2 - Snap Ring

  12. Position the press with the receiver on the remaining bearing cap and yoke.

    1 - Bearing Cap
    2 - Press
    3 - Receiver
  13. Press the remaining bearing cap until the snap ring groove is through the yoke.
  14. Install the snap ring on the bearing cap.

    1 - Bearing Cap
    2 - Snap Ring
  15. Install the driveshaft (Refer to 03 - Differential and Driveline/SHAFTS, Axle/Drive/Half/Removal and Installation) .