Removal and Installation
Differential Cover - M250
▸Contents: 03 - Differential and Driveline
Description and Operation
Diagnosis and Testing
ASSEMBLY, Differential
Disassembly and Assembly
Actuator/Motor
GEAR, Ring and Pinion
Removal and Installation
Joints
SHAFTS, Axle/Drive/Half
Valves
Removal and Installation
REMOVAL
- Raise and support the vehicle (Refer to 04 - Vehicle Quick Reference/Hoisting/Standard Procedure) .
- Remove the differential fill plug.
- Remove the differential drain plug located on the bottom of the axle housing and drain the fluid.
1 – drain plug - Install the differential drain plug.
- Remove the differential cover bolts and stud bolts.
1 – Differential Cover Bolts 2 – Differential Cover Stud Bolts - Remove the differential cover.
INSTALLATION
Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.
- Install a NEW differential cover gasket.
- Tighten the differential cover bolts and stud bolts in a criss-cross pattern.
- Fill to spec with the proper differential fluid (Refer to 04 - Vehicle Quick Reference/Capacities and Recommended Fluids/Specifications) .
TORQUE SPECIFICATIONS - M250 DIFFERENTIAL