2023 Ram 1500

Removal and Installation

Differential Cover - C235 - With Thermal Axle

▸Contents: 03 - Differential and Driveline

REMOVAL

  1. Drive the vehicle at least 2 miles (3.21 km) to warm the fluid.
  2. Raise and support the vehicle (Refer to 04 - Vehicle Quick Reference/Hoisting/Standard Procedure) .
  3. Drain the cooling system (Refer to 09 - Engine/Cooling Systems/Engine Cooling/Standard Procedure) .
  4. Remove the drain plug and drain the fluid.
  5. Remove the coolant line nuts and position the coolant lines aside.

    1 – Coolant Line Nuts
    2 – Coolant Lines

  6. Remove the differential cover bolts and remove the differential cover.

    1 – Differential Cover Bolts
    2 – Differential Cover

 

INSTALLATION

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

  • Clean all RTV from the cover and housing, do not damage the mating surfaces. Wipe the surfaces clean using brake cleaner or equivalent to verify there is no oily residue left behind.
  • Apply a 6.35 mm (1/4 in.) bead of Mopar™ Axle RTV Sealant to the cover with the bead to the inner side of the bolt holes.

    NOTE: Using other RTV sealers may cause a leak.

    CAUTION:

    If housing cover is not installed within 3 to 5 minutes, the cover must be cleaned and new RTV applied. Failure to follow these instructions will result in a leak.

  • Tighten the differential cover bolts in a criss-cross pattern
  • Check the seals on the coolant lines before installation and replace if necessary.
  • Fill to spec with the proper differential fluid (Refer to 04 - Vehicle Quick Reference/Capacities and Recommended Fluids/Specifications) .
 


TORQUE SPECIFICATIONS - C235 DIFFERENTIAL