Removal and Installation
Differential Side Bearings - C235
▸Contents: 03 - Differential and Driveline
Description and Operation
Diagnosis and Testing
ASSEMBLY, Differential
Disassembly and Assembly
Actuator/Motor
GEAR, Ring and Pinion
Removal and Installation
Joints
SHAFTS, Axle/Drive/Half
Valves
Removal and Installation
REMOVAL
- Raise and support the vehicle (Refer to 04 - Vehicle Quick Reference/Hoisting/Standard Procedure) .
- Remove the differential case from axle housing (Refer to 03 - Differential and Driveline/ASSEMBLY, Differential/Removal and Installation) .
- Remove the differential side bearings from the case using Puller, Press C-293-PA and Block Set, Puller C-293-47 and Adapter, Bearing/Gear C-293-3 .
1 - Puller, Press C-293-PA 2 - Block Set, Puller C-293-47 3 - Adapter, Bearing/Gear C-293-3 4 - Differential Case
INSTALLATION
Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.
- Install the differential side bearings using the Installer, Bearing 2073600030 and Driver Handle, Universal C-4171 .
- Install the differential case into the housing (Refer to 03 - Differential and Driveline/ASSEMBLY, Differential/Removal and Installation) .
1 - Installer, Bearing 2073600030 With Driver Handle, Universal C-4171 - Fill to spec with the proper differential fluid (Refer to 04 - Vehicle Quick Reference/Capacities and Recommended Fluids/Specifications) .
TORQUE SPECIFICATIONS - C235 DIFFERENTIAL