2023 Ram 1500

Removal and Installation

Front Halfshaft

▸Contents: 03 - Differential and Driveline

Right Hand (RH) or Left Hand (LH)

REMOVAL

  1. Raise and support the vehicle (Refer to 04 - Vehicle Quick Reference/Hoisting/Standard Procedure) .
  2. If equipped with air suspension, deflate the air suspension system (Refer to 02 - Front Suspension/Air Suspension/Standard Procedure) .
  3. Remove wheel and tire assembly (Refer to 22 - Tires and Wheels/Removal and Installation) .

    1 - Brake Caliper Bolts
    2 - Bleeder Dust Cover
  4. Remove brake caliper bolts and secure caliper aside.
  5. Remove ABS wheel speed sensor (Refer to 05 - Brakes, ABS/Electrical/SENSOR, Wheel Speed, Front/Removal and Installation) .
  6. If equipped with air suspension, remove the stabilizer bar link (Refer to 02 - Front Suspension/Front/LINK, Stabilizer Bar/Removal and Installation) .
  7. Remove and DISCARD the halfshaft hub nut from the halfshaft.

    1 - Halfshaft Hub Nut
    2 - Halfshaft
  8. Remove and DISCARD the upper ball joint nut.
  9. Separate upper ball joint from the steering knuckle with Ball Joint Remover - Remover, Ball Joint 8677

    1 - Upper Ball Joint Nut
    2 - Steering Knuckle

  10. Disengage the inner Constant Velocity (CV) joint from the front axle using a suitable tool.

    1 - Lower Control Arm
    2 - Constant Velocity (CV) Joint
  11. Pull down on the lower control arm and remove the halfshaft from the vehicle.
  12. Inspect the halfshaft O-ring sealing face and chamfer for corrosion and nicks. Clean the sealing face, if it is pitted or damaged replace the CV shaft.
 

INSTALLATION

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

  • Install a NEW front axle output shaft O-ring and circlip. Apply a light coating of Mopar™ High Temp Grease or equivalent to halfshaft sealing face.
  • Install a NEW front axle output shaft O-ring and circlip. Apply a light coating of Mopar™ High Temp Grease or equivalent to halfshaft sealing face.

    1 - Halfshaft
  • Install the halfshaft into the front axle. Push the inner CV joint firmly to engage the axle output shaft circlip into the halfshaft.

    NOTE: Perform a push-pull-push check on the inner CV joint to ensure that the halfshaft is properly seated to the axle output shaft. DO NOT PULL ON THE HALFSHAFT BAR or OUTER CV, push-pull-push is to be done on the inner CV only.
  • Install a NEW brake caliper bolts.
  • Install a NEW upper ball joint nut.
  • Install NEW halfshaft hub nut.
  • If equipped with air suspension, fill the air suspension system (Refer to 02 - Front Suspension/Air Suspension/Standard Procedure) .
 


TORQUE SPECIFICATIONS - FRONT SUSPENSION


TORQUE SPECIFICATIONS - BRAKES BASE


TORQUE SPECIFICATIONS - WHEEL LUG NUT