2023 Ram 1500

Removal and Installation

Axle Shaft - M250

▸Contents: 03 - Differential and Driveline

REMOVAL

  1. Raise and support the vehicle (Refer to 04 - Vehicle Quick Reference/Hoisting/Standard Procedure) .
  2. Remove the rear brake rotor (Refer to 05 - Brakes, Base/Hydraulic/Mechanical/ROTOR, Brake/Removal and Installation) .
  3. Using a hammer and punch, remove the axle shaft dust cover and DISCARD .

    1 - Dust Cover

  4. Remove the wheel speed sensor bolt and remove the wheel speed sensor wire harness support.

    1 - Wheel Speed Sensor Bolts
    2 - Wheel Speed Sensor Wire Harness Support

  5. Remove the axle bearing bolts.

    1 - Axle Bearing Bolts

  6. Remove the axle shaft with the hub and bearing from the axle tube.

    1 - Hub And Bearing

  7. Support the hub and bearing, press out the axle shaft using a properly sized socket.

    1 - Socket
    2 - Hub And Bearing

 

INSTALLATION

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

  • Install a new O-ring seal onto the bearing housing. Lubricate lightly with axle lubricant before installing in the axle housing.
  • Install a NEW axle shaft dust cover using a properly sized socket and hammer.
 


TORQUE SPECIFICATIONS - M250 DIFFERENTIAL


TORQUE SPECIFICATIONS - BRAKES BASE


TORQUE SPECIFICATIONS - WHEEL LUG NUT