Diagnosis and Testing
Halfshaft
▸Contents: 03 - Differential and Driveline
Description and Operation
Diagnosis and Testing
ASSEMBLY, Differential
Disassembly and Assembly
Actuator/Motor
GEAR, Ring and Pinion
Removal and Installation
Joints
SHAFTS, Axle/Drive/Half
Valves
Removal and Installation
| CAUTION: |
Boot sealing is vital to retain special lubricants and to prevent foreign contaminants from entering the CV joint. Mishandling, such as allowing the assemblies to dangle unsupported, or pulling or pushing the ends can cut boots or damage CV joints. During removal and installation procedures, always support both ends of the halfshaft to prevent damage. |
Halfshafts can cause unwanted noise or vibration. Typical causes of noise are worn Constant Velocity (CV) joints or, if equipped, a worn or damaged intermediate shaft bearing. These conditions can also induce vibration. Halfshaft vibrations can also be caused by impact damage or material that has attached or adhered to the halfshaft.
A loss of drive condition may be experienced if there is damage to the machined splines. The shaft itself has splines at each end to engage the CV joints, the inner CV joint has splines to engage with the differential to drive the shaft, and the outer CV joint is splined to the hub that is driven by the halfshaft.
Common items to check when a halfshaft NVH issue is suspected:
- Visually inspect halfshaft joint boots for lubrication leaks.
- Visually inspect driveshaft for evidence of impact damage.
- Inspect for any components that maybe coming into contact with the halfshaft, remembering that the halfshaft moves with the vehicle suspension.
- Verify all fasteners are present and correctly torqued.
- Verify the halfshaft is fully installed and properly secured into the differential.
- If equipped within intermediate shaft, make sure the intermediate shaft bearing is properly installed and in good condition.
- Verify all engine mounts and axle mounts are in good condition.
CV JOINT DIAGNOSTICS
- If a popping or snapping type noise is experienced when a gear is engaged with the brakes applied, check the hub nut torque. Some halfshafts use a coated washer to mitigate this noise, make sure these are present and in condition when diagnosing.
- A clicking or popping type noise when the vehicle is negotiating a turn can be caused by damaged components of an outer CV joint.
- A vibration or shudder when the drivetrain is under a load or when initially launching the vehicle can be caused worn or damaged inner CV joint components. The inner CV joint is designed to allow for the halfshaft to change length when the vehicle is turning or during suspension articulation. Due to this movement, the vibration or shudder may be more pronounced in specific situations.