Removal and Installation
Rear Driveshaft
▸Contents: 03 - Differential and Driveline
Description and Operation
Diagnosis and Testing
ASSEMBLY, Differential
Disassembly and Assembly
Actuator/Motor
GEAR, Ring and Pinion
Removal and Installation
Joints
SHAFTS, Axle/Drive/Half
Valves
Removal and Installation
REMOVAL
- Raise and support the vehicle (Refer to 04 - Vehicle Quick Reference/Hoisting/Standard Procedure) .
- If equipped, remove the skid plate (Refer to 13 - Frame and Bumpers/Under Body Protection/PLATE, Skid, Front/Removal and Installation) .
- If equipped with a two piece driveshaft, using a long piece of wood or similar, fasten it to the driveshaft with several cable ties in order to keep the driveshaft from over-articulating during removal and installation.
- Paint or scribe alignment marks on the axle companion flange, driveshaft, flange yoke and transmission case for installation reference.
- Remove the rear driveshaft to rear axle bolts.
1 - Rear Driveshaft to Rear Axle Bolts - If equipped, remove the rear driveshaft center support bearing bolts.
CAUTION: Driveshaft removal is a two-person operation. Never allow the driveshaft to hang from the center bearing, or while only connected to the transmission or rear axle flanges. An assistant is required. If a driveshaft section is hung unsupported, damage may occur to the shaft, joint and center bearing from over-angulation. This may result in driveline vibrations or component failure.
1 - Rear Driveshaft Center Support Bearing Bolts - If drive shaft is equipped with slip yoke, remove the rear driveshaft by sliding the slip yoke out of the transmission or transfer case.
- If drive shaft is equipped with flange, remove the driveshaft to transfer case or transmission flange bolts and remove the driveshaft.
INSTALLATION
Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.
- If the drive shaft attaches to the transfer case or transmission with flange align all of the reference marks aligned.
- Install the rear driveshaft to the axle with all of the reference marks aligned.
TORQUE SPECIFICATIONS - DRIVESHAFT