Disassembly and Assembly
C235 - Open Differential
▸Contents: 03 - Differential and Driveline
Description and Operation
Diagnosis and Testing
ASSEMBLY, Differential
Disassembly and Assembly
Actuator/Motor
GEAR, Ring and Pinion
Removal and Installation
Joints
SHAFTS, Axle/Drive/Half
Valves
Removal and Installation
DISASSEMBLY
- Remove the differential case assembly from the differential housing (Refer to 03 - Differential and Driveline/ASSEMBLY, Differential/Removal and Installation) .
- Remove the side bearings (Refer to 03 - Differential and Driveline/BEARINGS/Removal and Installation) .
- Remove and DISCARD the pinion mate shaft lock screw.
1 – Pinion Mate Shaft Lock Screw 2 – Pinion Mate Shaft - Remove the pinion mate shaft.
- Rotate both of the differential pinion gears to the differential window and remove both pinion gears and thrust washers.
1 – Differential Side Gears 2 – Differential Pinion Gears
NOTE: Mark each side gear, pinion gear and thrust washer location using a paint pen if they are being re-used.
- Remove the differential side gears and the thrust washers.
1 – Differential Side Gears 2 – Differential Pinion Gears
ASSEMBLY
| NOTE: |
If re-using the side gears, pinion gears and thrust washers, install them into their original locations. |
- Lubricate all of the differential components with axle lubricant.
- Install the differential side gears with the thrust washers through the differential window.
1 – Differential Side Gears 2 – Differential Pinion Gears - Install both pinion gears with the thrust washers into the differential window and mate them with the side gears. Rotate both pinion gears into the case.
1 – Differential Side Gears 2 – Differential Pinion Gears - Rotate the gears to align the hole in the pinion gears with the hole in the differential case.
1 – Pinion Gears 2 – Differential Case - Slide the pinion mate shaft into the case and through the pinion gears.
NOTE: Do NOT torque the pinion mate shaft lock screw until the side gear clearance is set.
1 – Pinion Mate Shaft Lock Screw 2 – Pinion Mate Shaft - Install a NEW pinion mate shaft lock screw in the differential case to secure the pinion shaft. DO NOT TORQUE THE PINION MATE SHAFT LOCK SCREW AT THIS TIME.
- Install NEW differential case side bearings (Refer to 03 - Differential and Driveline/BEARINGS/Removal and Installation) .
- Install the case assembly into the differential housing (Refer to 03 - Differential and Driveline/ASSEMBLY, Differential/Removal and Installation) .