Removal and Installation
Axle Seal - Rba260
▸Contents: 03 - Differential and Driveline
Description and Operation
Diagnosis and Testing
ASSEMBLY, Differential
Disassembly and Assembly
Actuator/Motor
GEAR, Ring and Pinion
Removal and Installation
Joints
SHAFTS, Axle/Drive/Half
Valves
Removal and Installation
REMOVAL
- Raise and support the vehicle (Refer to 04 - Vehicle Quick Reference/Hoisting/Standard Procedure) .
- Remove axle shaft (Refer to 03 - Differential and Driveline/SHAFTS, Axle/Drive/Half/Removal and Installation) .
- Remove axle shaft seal from the axle tube with a seal puller.
1 – Axle Shaft Seal
INSTALLATION
Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.
- Wipe the axle tube bore clean with brake cleaner. Remove any old sealer or burrs from the tube.
- Install a NEW axle shaft seal using Installer, Seal C-4076-B and Handle, Driver C-4735 .
NOTE: When the tool contacts the axle tube, the seal is installed to the correct depth.
1 – Installer, Seal C-4076-B With Handle, Driver C-4735 2 – Axle Shaft Seal - Fill the differential to the specified level using the specified fluid (Refer to 04 - Vehicle Quick Reference/Capacities and Recommended Fluids/Specifications) .
TORQUE SPECIFICATIONS - RBA260 INTERNAL