Diagnosis and Testing
Driveshaft
▸Contents: 03 - Differential and Driveline
Description and Operation
Diagnosis and Testing
ASSEMBLY, Differential
Disassembly and Assembly
Actuator/Motor
GEAR, Ring and Pinion
Removal and Installation
Joints
SHAFTS, Axle/Drive/Half
Valves
Removal and Installation
| CAUTION: |
Driveshaft installation is a two-person operation. Never allow driveshaft to hang from the center bearing, or while only connected to the transmission, transfer case or axle flanges. A helper is required. If a driveshaft section is hung unsupported, damage may occur to the shaft, coupler, and center bearing from over-angulation. This may result in driveline vibrations or component failure. |
Driveshafts can cause unwanted noise or vibration. Typical causes of noise are worn joints and if equipped, worn or damaged center support bearing(s) on multi-piece driveshafts. These conditions can also induce vibration. Driveshaft vibrations can also be caused by impact damage, material that has attached or adhered to the driveshaft or an out of balance driveshaft. Driveshaft related vibrations tend to get worse as vehicle speed increases.
Common items to check when a driveshaft NVH issue is suspected:
- Visually inspect driveshaft joints for lubrication leaks.
- Visually inspect driveshaft for evidence of impact damage.
- Inspect for any components that maybe coming into contact with the driveshaft, remembering that the driveshaft moves with the vehicle suspension.
- Visually inspect driveshaft for evidence of missing balancing weights.
- Verify all fasteners are present and correctly torqued.
- Verify all engine mounts and axle mounts are in good condition.
- Some driveshafts have sliding components other than a slip yoke to allow for changes in length as the suspension articulates, these are usually protected with a boot. Some driveshafts also provide a means to lubricate this joint. Make sure the boot is in good condition, and the proper lubricant is present . If this joint becomes bound, unusual noise and harshness may occur when traveling over uneven road surfaces.
- Use the Mopar® Scope to verify if the driveshaft is the source of a complaint prior to replacing a driveshaft if there are no obvious signs of damage. Refer to (Refer to 29 - Non-DTC Diagnostics/Noise, Vibration, Harness/Diagnosis and Testing) .