Removal and Installation
Differential Side Bearings - M250
▸Contents: 03 - Differential and Driveline
Description and Operation
Diagnosis and Testing
ASSEMBLY, Differential
Disassembly and Assembly
Actuator/Motor
GEAR, Ring and Pinion
Removal and Installation
Joints
SHAFTS, Axle/Drive/Half
Valves
Removal and Installation
REMOVAL
- Remove the differential case from the axle housing (Refer to 03 - Differential and Driveline/ASSEMBLY, Differential/Removal and Installation) .
- Remove the flange side differential bearing using Puller, Press C-293-PA , Adapters, Puller 9614 and Adapter Plug 9676 .
1 - Puller, Press C-293-PA 2 - Adapter Plug 9676 3 - Adapters, Puller 9614 4 - Puller, Press C-293-PA 5 - Differential Side Bearing
INSTALLATION
Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.
- Install the flange side differential side bearing using the Installer, Ball Joint 6761 and a sufficient hydraulic press.
- Install the differential into the axle housing (Refer to 03 - Differential and Driveline/ASSEMBLY, Differential/Removal and Installation) .
1 - Installer, Ball Joint 6761 2 - Differential Side Bearing - Fill to spec with the proper differential fluid (Refer to 04 - Vehicle Quick Reference/Capacities and Recommended Fluids/Specifications) .
TORQUE SPECIFICATIONS - M250 DIFFERENTIAL