Removal and Installation
Output Shaft Bearing - 215fd
▸Contents: 03 - Differential and Driveline
Description and Operation
Diagnosis and Testing
ASSEMBLY, Differential
Disassembly and Assembly
Actuator/Motor
GEAR, Ring and Pinion
Removal and Installation
Joints
SHAFTS, Axle/Drive/Half
Valves
Removal and Installation
DISASSEMBLY
- Remove the output shaft (Refer to 03 - Differential and Driveline/SHAFTS, Axle/Drive/Half/Removal and Installation) .
- Remove the snap ring from the output shaft.

1 - Snap Ring 2 - Output Shaft - Press the output shaft out of the output shaft bearing.

1 - Output Shaft Bearing 2 - Output Shaft
INSTALLATION
Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.
- Press the output shaft bearing on to the output shaft.
- Verify that the snap ring is seated completely on the output shaft.

1 - Output Shaft Bearing 2 - Output Shaft - Fill to spec with the proper differential fluid (Refer to 04 - Vehicle Quick Reference/Capacities and Recommended Fluids/Specifications) .
TORQUE SPECIFICATIONS - 215FD FRONT AXLE