Removal and Installation
Differential Cover - Rba260
▸Contents: 03 - Differential and Driveline
Description and Operation
Diagnosis and Testing
ASSEMBLY, Differential
Disassembly and Assembly
Actuator/Motor
GEAR, Ring and Pinion
Removal and Installation
Joints
SHAFTS, Axle/Drive/Half
Valves
Removal and Installation
REMOVAL
- Drive the vehicle at least 2 miles (3.21 km) to warm the fluid.
- Raise and support the vehicle (Refer to 04 - Vehicle Quick Reference/Hoisting/Standard Procedure) .
- Remove the drain plug and drain the fluid.
1 - Drain Plug 2 - Fill Plug - Remove the differential cover bolts.
1 – Differential Cover Bolts - Remove the differential cover.
INSTALLATION
Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.
- Clean all RTV from the cover and housing, do not damage the mating surfaces. Wipe the surfaces clean using brake cleaner or equivalent to verify there is no oily residue left behind.
- Tighten the differential cover bolts in a criss-cross pattern.
- Fill to spec with the proper differential fluid (Refer to 04 - Vehicle Quick Reference/Capacities and Recommended Fluids/Specifications) .
TORQUE SPECIFICATIONS - RBA260 INTERNAL