Removal and Installation
Removal And Installation - Single Cardan With Snap Rings
▸Contents: 03 - Differential and Driveline
Description and Operation
Diagnosis and Testing
ASSEMBLY, Differential
Disassembly and Assembly
Actuator/Motor
GEAR, Ring and Pinion
Removal and Installation
Joints
SHAFTS, Axle/Drive/Half
Valves
Removal and Installation
REMOVAL
- Remove the driveshaft (Refer to 03 - Differential and Driveline/SHAFTS, Axle/Drive/Half/Removal and Installation) .
- Tap the outside of the bearing cap with a drift to loosen the snap ring.

1 - Snap Rings - Remove the snap rings from both sides of the yoke.
- Position the yoke with the grease fitting (if equipped) pointing up.

1 - Press 2 - Socket - Position a socket with an inside diameter large enough to receive the bearing cap, beneath the yoke on a press.
- Place another socket with an outside diameter smaller than the bearing cap on the upper bearing cap and press the lower cap through the yoke.
NOTE: If the bearing cap will not pull out of the yoke after pressing, tap yoke the ear near the bearing cap to dislodge the cap.
- Pull the bearing cap out of the yoke.

1 - U-Joint 2 - Bearing Cap - Turn the yoke over in the press and straighten the U-Joint. Press the U-Joint until the remaining bearing cap can be removed.
| CAUTION: |
If cross or bearing cap are not straight during removal, the bearing cap will score the walls of the yoke bore and damage can occur. |
INSTALLATION
- Position the U-Joint in the yoke with the grease fitting pointing up (if equipped).

1 - U-Joint 2 - Yoke - Place a bearing cap over the U-Joint end and align the cap with the yoke bore.

1 - Bearing Cap 2 - U-Joint End - Press the bearing cap into the yoke bore enough to clear the snap ring groove.
- Repeat steps 1–4 to install the opposite bearing cap.
NOTE: If the U-Joint is stiff or binding, strike the yoke with a soft hammer to seat the needle bearings.
- Grease the fitting, if equipped.
- Install the driveshaft (Refer to 03 - Differential and Driveline/SHAFTS, Axle/Drive/Half/Removal and Installation) .